IDS peak 2.10.0 / uEye+ firmware 3.34

IDS Peak comfortSDK, genericSDK, IPL, and AFL developer manuals are external documents. Please contact us if you need them.

Image acquisition

•If you increase the exposure time so that the frame rate drops, a single image can be defective.

•To achieve the maximum frame rate, you must set DeviceLinkThroughputLimit to the maximum value.

•To achieve the minimum exposure time, you must set DeviceLinkThroughputLimit to the maximum value.

•To achieve the maximum exposure time, you must set DeviceLinkThroughputLimit to the minimum value.

•As the models do not have an image memory, images may be lost under certain circumstances. In this case, reduce the value of DeviceLinkThroughputLimit. Note, however, that this lowers the frame rate and may cause a rolling shutter effect.

Sensor

•Due to the sensor, the upper 65 lines in the image are always black. These lines are automatically cropped in IDS peak.

•Due to the manufacturer, the minimum (0) and maximum (255) data values are not used for the 8-bit pixel format.

ROI

•The frame rate does not increase by the use of a horizontal ROI.

Binning

•Sensor binning is only supported by monochrome sensors.

Decimation

•The frame rate does not increase with horizontal decimation.

•Sensor decimation is only supported by color models.

Trigger

•In trigger mode, the "ExposureActive" signal is always present on the flash output (Line1). The signal cannot be switched off.

uEye+ XCP USB 3/uEye+ XLS USB 3

The model does not support the following features:

•Automatic exposure (ExposureAuto)
Alternatively, you can perform auto exposure on the host.

•Automatic gain (GainAuto)
Alternatively, you can perform the gain functions on the host.

•Automatic white balance (BalanceWhiteAuto)
Alternatively, you can perform the automatic white balance on the host.

•Chunks (ChunkDataControl)

•Counter and timer (CounterAndTimerControl)

•Events (EventControl)

•Color correction (ColorCorectionMode)
Alternatively, you can perform color correction on the host.

•FPGA binning (BinningSelector)
Alternatively, you can use IDS peak IPL to perform binning on the host.

•FPGA decimation (DecimationSelector)
Alternatively, you can use IDS peak IPL to perform decimation on the host.

•Gamma (Gamma)
Alternatively, you can use IDS peak IPL to perform gamma on the host.

•Line scan mode (SensorOperationMode "Linescan")

•LUT (LUTControl)

•Pulse-width modulation (PWMControl)

•Sequencer (SequencerControl)

USB 2.0 operation

•The camera model does not support USB 2.0 operation.