IDS Software Suite 4.96.1
|
Note on the wide range power input GigE uEye SE series cameras with a production date of Q4/2010 or later feature a wide range power input. You can recognize these cameras by the label "12-24V DC" on their back side. You can operate these cameras with voltage between 12 and 24 V DC. |
6-pin Hirose connector (HR10A-7R-6PB)
Pin |
Description |
 Fig. 691: GigE uEye SE - Hirose connector male, camera rear view |
|---|---|---|
1 |
Ground (GND) |
|
2 |
Power supply (VCC) |
|
3 |
Trigger input with optocoupler (-) |
|
4 |
Trigger input with optocoupler (+) |
|
5 |
Flash output with optocoupler (+) |
|
6 |
Flash output with optocoupler (-) |
You can check the color assignment of the cable on the Website directly at the specific accessory item.
 |
The maximum length of the I/O cable is 30 m. The cable must be shielded. |
Power supply
Voltage |
Tolerance |
Residual ripple |
|---|---|---|
12 V (12 V version) |
+/- 10 % |
max. 120 mVpp |
12-24 V (24 V version) |
+/- 10 % |
max. 120 mVpp |
IDS Imaging Development Systems GmbH recommends to adjust the power supply to the power requirement of the camera to limit overheating in case of short circuit.
To ensure the electrical safety, the camera power supply must meet the requirements for SELV (safety extra low voltage) / LPS (limited power source) or ES1 / PS2. The camera power supply must be rated by the values given in the table above. It also must ensure that the voltage values given in the table above are available at the input of the camera.
Avis pour le Canada:
IDS Imaging Development Systems GmbH recommande d'adapter l'alimentation électrique aux besoins de la caméra afin de limiter la surchauffe en cas de court-circuit.
Pour garantir la sécurité électrique, l'alimentation de la caméra doit être conforme aux exigences de sécurité SELV (très basse tension de sécurité)/LPS (source à puissance limitée) ou ES1/PS2. L'alimentation de la caméra doit respecter les valeurs indiquées dans le tableau ci-dessus. Elle doit également répondre au fait que les tensions indiquées dans le tableau ci-dessus sont présentes à l'entrée de la caméra.
Information on the power consumption of individual camera models can be found in the model data sheet.
|
Keep in mind that a voltage drop will occur when you use long cables for power supply to the camera. Choose the size of the cable in such a way that the supply voltage available at the input of the camera is at least 12 V. |
|
Note on inrush current The inrush current of the GigE uEye SE cameras may temporarily increase to up to 2 A. |
