NOTICE! The General Purpose I/Os are not potential-free and have no protective circuit. Faulty wiring (overvoltage, undervoltage) can result in a damage in the electronics. |
8-pin Hirose connector (HR25-7TR-8PA(73))
Pin |
Description |
Fig. 504: USB uEye ML, Hirose connector male, camera rear view |
---|---|---|
1 |
Ground (GND) |
|
2 |
Flash output with optocoupler (-) |
|
3 |
General purpose I/O (GPIO) 1, 3.3 V |
|
4 |
Trigger input with optocoupler (-) |
|
5 |
Flash output with optocoupler (+) |
|
6 |
General purpose I/O (GPIO) 2, 3.3 V |
|
7 |
Trigger input with optocoupler (+) |
|
8 |
not connected |
You can check the color assignment of the cable on the Website directly at the specific accessory item.
The maximum length of the I/O cable is 30 m. The cable must be shielded. |
Power supply
The camera is supplied with power via the USB 2.0 interface. For information on the camera's power consumption, please refer to the Camera and sensor data section.