Please enable JavaScript to view this site.

IDS Software Suite 4.96.1

 

Camera specifications

Design

Mechanical specifications USB 3 uEye CP

Housing/board level

+/-

Dimensions height x width x depth

29 x 29 x 29 mm

IP code

IP 30

Protection against the ingression of small particles (diameter ≥ 2.5 mm)

No protection against water

Lens mount

C-mount, see Optical specifications USB 3 uEye CP

Mounting holes bottom/top/side/front

4/0/0/0

Thread diameter

M3

Status LED

Status LED USB 3 uEye CP

Ambient conditions

Ambient conditions USB 3 uEye CP

Connectors

Electrical specifications USB 3 uEye CP

Interface connector

USB 3.0 micro B, screwable

Power supply

USB

I/O connector

8-pin Hirose HR25, screwable

Optocoupler for I/O

1/1

Trigger input/Flash output/GPIO

1/1/2

PWM (pulse-width modulation)

+

Serial interface

+ (GPIO)

TWI (Two Wire Interface)

-

Special features

Internal pixel preprocessing

Image memory (approximately)

-

hint_info

USB 3/USB 3.1 uEye cameras are limited usable under USB 2.0. Depending on the camera model, not all camera functions are available in USB 2.0 mode. USB 3/USB 3.1 uEye cameras are optimized for USB 3.0 ports and are not tested by IDS Imaging Development Systems GmbH under USB 2.0.

Please note that due to the high performance of modern sensors, some USB 3/USB 3.1 uEye models are not supported in USB 2.0 mode anymore, as the USB 2.0 interface does not provide enough power.

© 2022 IDS Imaging Development Systems GmbH