Please enable JavaScript to view this site.

IDS Software Suite 4.96.1

 

Camera specifications

Design

Mechanical specifications USB 3 uEye LE

Housing/board level

+/-

Dimensions height x width x depth

Housing version: 47 x 46 x 26.3 mm

PCB version: 36 x 36 x 9.8 mm

PCB version with S-mount: 36 x 36 x 22 mm

IP code housing version

IP 30

Protection against the ingression of small particles (diameter ≥ 2.5 mm)

No protection against water

IP code PCB version

IP 00

No protection against the ingression of particles

No protection against water

Lens mount

S-/CS-/C-mount, see Optical specifications USB 3 uEye LE

Mounting holes bottom/top/side/front

Housing version: 2/0/0/0

PCB version: 0/0/0/4

Thread diameter

Housing version: M3

Status LED

Status LED USB 3 uEye LE

Ambient conditions

Ambient conditions USB 3 uEye LE

Connectors

Electrical specifications USB 3 uEye LE

Interface connector

USB 3.0 micro B, screwable

Power supply

USB

I/O connector

PCB version: 8-pin plated-through holes

Optocoupler for I/O

-/-

Trigger input/Flash output/GPIO

1/1/2

PWM (pulse-width modulation)

+

Serial interface

-

TWI (Two Wire Interface)

PCB version: +

Special features

Internal pixel preprocessing

PCB version with I/O connector

Image memory (approximately)

-

hint_info

USB 3/USB 3.1 uEye cameras are limited usable under USB 2.0. Depending on the camera model, not all camera functions are available in USB 2.0 mode. USB 3/USB 3.1 uEye cameras are optimized for USB 3.0 ports and are not tested by IDS Imaging Development Systems GmbH under USB 2.0.

Please note that due to the high performance of modern sensors, some USB 3/USB 3.1 uEye models are not supported in USB 2.0 mode anymore, as the USB 2.0 interface does not provide enough power.

© 2022 IDS Imaging Development Systems GmbH