Please enable JavaScript to view this site.

IDS Software Suite 4.96.1

The "Draw" menu contains functions drawing annotations as overlay on the live image.

Setting the measuring unit

You can take simple measurements in uEye Cockpit. Before you start measuring, the camera has to be calibrated to a scale. The []/pixel unit indicates the actual distance that corresponds to one pixel. To set the measuring unit, do the following:

1.Mount the camera on a stand. Place an object of known size below the camera (e.g. a ruler).

2.Make sure that the measuring unit is set to 1 at first. Then draw a dimension line over a known distance. The longer you make the dimension line, the higher the measurement accuracy will be.

3.The dimension line will show the length in pixels. Divide the actual distance by the number of pixels measured. Enter this value in the “Set measuring unit” field of the dialog box.

Example: Actual distance = 10 cm. Measured length in pixels = 200. Measuring unit = 10 cm/200 or 100 mm/200

hint_info

Note: Drawings are not displayed in full screen and in the view modes Direct3D and OpenGL. When switching back to DIB mode, drawings are displayed again.

Select Color

Select color for drawings and text

Geometry

 

Select line width

Set line width

Circle

 

Show circles

Show/hide circles

New circle

Draw new circle

Delete circles

Delete circles

Freehand

 

Show freehand lines

Show/hide freehand drawings

New freehand line

Draw new freehand

Delete freehand lines

Delete freehand drawing

Line

 

Show lines

Show/hide lines

New line

Draw new line

Delete lines

Delete lines

Rectangle

 

Show rectangles

Show/hide rectangles

New rectangle

Draw new rectangle

Delete rectangles

Delete rectangles

Measure

 

Set measuring unit

Set scale

Show measures

Show/hide dimension lines

New measure

Draw new dimension line

Delete measures

Delete all dimension lines

Text

 

Select font

Select font

Show texts

Show/hide texts

New text

Write new text

Delete text

Delete text

Time stamp

 

Set timestamp position

Timestamp position
(top left, top right, bottom left, bottom right)

Show timestamp

Show/hide timestamp

Crosshairs

Show/hide crosshairs

Save image + drawings

Opens the "Save As" dialog box. The image is stored with all drawings, texts, measures and dimension lines

Load drawings

Loads saved drawings from a *.bin file.

Save drawings

Saves current drawings to *.bin file.

Delete all

Delete all drawings, texts, measures and dimension lines

© 2022 IDS Imaging Development Systems GmbH