IDS Software Suite 4.96.1
|
Camera specifications |
|---|---|
Design |
|
Housing/board level |
+/+ |
Dimensions height x width x depth |
Housing version: 47 x 46 x 24.3 mm PCB version: 36 x 36 x 8.6 mm PCB version with CS-mount: 36 x 36 x 19.7 mm PCB version with S-mount: 36 x 36 x 19.9 mm |
IP code housing version |
IP 30 •Protection against the ingression of small particles (diameter ≥ 2.5 mm) •No protection against water |
IP code PCB version |
IP 00 •No protection against the ingression of particles •No protection against water |
Lens mount |
S-/C-/CS-mount, see Optical specifications uEye LE USB 3.1 Gen 1 |
Mounting holes bottom/top/side/front |
Housing version: 2/0/0/0 PCB version: 4x back, see Notes on PCB version uEye LE USB 3.1 Gen 1 |
Thread diameter |
M3 |
Status LED |
|
Ambient conditions |
|
Connectors |
|
Interface connector |
USB Type-C®, screwable |
Power supply |
USB |
I/O connector |
|
Optocoupler for I/O |
-/- |
Trigger input/Flash output/GPIO |
1/1/2 |
PWM (pulse-width modulation) |
- |
Serial interface |
- |
TWI (Two Wire Interface) |
PCB version: + |
Special features |
Supports USB Power Delivery |
Image memory (approximately) |
- |
|
USB 3/USB 3.1 uEye cameras are limited usable under USB 2.0. Depending on the camera model, not all camera functions are available in USB 2.0 mode. USB 3/USB 3.1 uEye cameras are optimized for USB 3.0 ports and are not tested by IDS Imaging Development Systems GmbH under USB 2.0. Please note that due to the high performance of modern sensors, some USB 3/USB 3.1 uEye models are not supported in USB 2.0 mode anymore, as the USB 2.0 interface does not provide enough power. |
