|
Camera specifications |
---|---|
Design |
|
Housing/board level |
+/+ |
Dimensions height x width x depth |
Housing version: 44 x 44 x 25.6 mm PCB version: 36 x 36 x 5.7 mm PCB version with S-mount: 36 x 36 x 20.2 mm |
IP code housing version |
IP 30 •Protection against the ingression of small particles (diameter ≥ 2.5 mm) •No protection against water |
IP code PCB version |
IP 00 •No protection against the ingression of particles •No protection against water |
Lens mount |
S-/CS-/C-mount, see Optical specifications USB uEye LE |
Mounting holes bottom/top/side/front |
Housing version: 1/0/0/0 PCB version: 0/0/0/4 |
Thread diameter |
5/8" |
Status LED |
|
Ambient conditions |
|
Connectors |
|
Interface connector |
USB 2.0 mini B Note: The USB cable connected to the camera must not be routed outside buildings when the USB cable of the camera is connected to a widely distributed USB network. |
Power supply |
USB |
I/O connector |
PCB version: 10-pin plated-through holes |
Optocoupler for I/O |
-/- |
Trigger input/Flash output/GPIO |
PCB version: 1/1/2 |
PWM (pulse-width modulation) |
- |
Serial interface |
- |
TWI (Two Wire Interface) |
PCB version: + |
Special features |
|
Image memory (approximately) |
- |