IDS Software Suite 4.96.1
|
Camera specifications |
|---|---|
Design |
|
Housing/board level |
+/- |
Dimensions height x width x depth |
47 x 46 x 28 mm |
IP code |
IP 30 •Protection against the ingression of small particles (diameter ≥ 2.5 mm) •No protection against water |
Lens mount |
CS-/C-mount, see Optical specifications USB 3 uEye ML |
Mounting holes bottom/top/side/front |
2/0/0/0 |
Thread diameter |
M3 |
Status LED |
|
Ambient conditions |
|
Connectors |
|
Interface connector |
USB 3.0 micro B, screwable |
Power supply |
USB |
I/O connector |
8-pin Hirose HR25, screwable |
Optocoupler for I/O |
1/1 |
Trigger input/Flash output/GPIO |
1/1/2 |
PWM (pulse-width modulation) |
+ |
Serial interface |
+ (GPIO) |
TWI (Two Wire Interface) |
- |
Special features |
|
Image memory (approximately) |
- |
|
USB 3/USB 3.1 uEye cameras are limited usable under USB 2.0. Depending on the camera model, not all camera functions are available in USB 2.0 mode. USB 3/USB 3.1 uEye cameras are optimized for USB 3.0 ports and are not tested by IDS Imaging Development Systems GmbH under USB 2.0. Please note that due to the high performance of modern sensors, some USB 3/USB 3.1 uEye models are not supported in USB 2.0 mode anymore, as the USB 2.0 interface does not provide enough power. |
