Please enable JavaScript to view this site.

IDS Software Suite 4.96.1

 

Camera specifications

Design

Mechanical specifications GigE uEye RE PoE

Housing/board level

+/-

Dimensions height x width x depth

CMOS: 53 x 41 x 39.7 mm

CCD: 53 x 41 x 44.7 mm

IP code

IP 65

Protection against penetration of dust: No ingression of dust at a vacuum of 20 mbar in the housing

Protection against water (out of a nozzle) from all directions
Test conditions: Using a jet nozzle with an inside diameter of 6.3 mm, a jet of water at a volume flow of 12.5 liters per minute is applied to the housing from all directions at a distance of 2.5-3 m. The testing period is at least 3 min.

IP 67

Protection against penetration of dust: No ingression of dust at a vacuum of 20 mbar in the housing

Protection against ingress of water in case of temporary immersion
Test conditions: The housing is dipped completely under water in a dip tank. The submerged depth is 1 m and the testing period is 30 min. Water may not intrude in a quantity which causes harmful effects while the housing is dipped in water under standardized pressure and time conditions.

Lens mount

C-mount, see Optical specifications GigE uEye RE PoE

Mounting holes bottom/top/side/front

9/7/10/0

Thread diameter

M2/M3/M5

Status LED

Status LED Gige uEye RE PoE

Ambient conditions

Ambient conditions GigE uEye RE PoE

Connectors

Electrical specifications GigE uEye RE PoE

Interface connector

GigE M12, screwable

Power supply

PoE or 12-24 V external

I/O connector

8-pin Binder connector, screwable

Optocoupler for I/O

1/1

Trigger input/Flash output/GPIO

1/1/2

PWM (pulse-width modulation)

+

Serial interface

-

TWI (Two Wire Interface)

-

Special features

Internal pixel pre-processing

Power supply with Power-over-Ethernet

Image memory (approximately)

60 MB

© 2022 IDS Imaging Development Systems GmbH