IDS Software Suite 4.96.1
10-pin Molex connector (Pico Blade)
Pin |
Description |
 Fig. 617: GigE uEye LE - Molex connector |
|---|---|---|
1 |
Ground (GND) |
|
2 |
VOUT 3.1 V max. 100 mA |
|
3 |
Trigger input without optocoupler |
|
4 |
Flash output without optocoupler |
|
5 |
General Purpose I/O (GPIO) 1 |
|
6 |
General Purpose I/O (GPIO) 2 |
|
7 |
TWI (Two Wire Interface) clock signal (internal 2k2 pull-up to VINT*) |
|
8 |
TWI (Two Wire Interface) data signal (internal 2k2 pull-up to VINT*) |
|
9 |
VIN+ 12 V - 24 V |
|
10 |
VIN- (GND) |
* Internal supply voltage: 3.1 V
You can check the color assignment of the cable on the Website directly at the specific accessory item.
 |
The maximum length of the I/O cable is 30 m. The cable must be shielded. |
2-pin terminal strip
Pin |
Description |
 Fig. 618: GigE uEye LE - 2-pin strip terminal |
|---|---|---|
1 |
VIN+ 12 V - 24 V |
|
2 |
VIN- (GND) |
Power supply
Voltage |
Tolerance |
Residual ripple |
|---|---|---|
12-24 V |
12 V - 10 % 24 V + 10 % |
max. 120 mVpp |
IDS Imaging Development Systems GmbH recommends to adjust the power supply to the power requirement of the camera to limit overheating in case of short circuit.
To ensure the electrical safety, the camera power supply must meet the requirements for SELV (safety extra low voltage) / LPS (limited power source) or ES1 / PS2. The camera power supply must be rated by the values given in the table above. It also must ensure that the voltage values given in the table above are available at the input of the camera.
Avis pour le Canada:
IDS Imaging Development Systems GmbH recommande d'adapter l'alimentation électrique aux besoins de la caméra afin de limiter la surchauffe en cas de court-circuit.
Pour garantir la sécurité électrique, l'alimentation de la caméra doit être conforme aux exigences de sécurité SELV (très basse tension de sécurité)/LPS (source à puissance limitée) ou ES1/PS2. L'alimentation de la caméra doit respecter les valeurs indiquées dans le tableau ci-dessus. Elle doit également répondre au fait que les tensions indiquées dans le tableau ci-dessus sont présentes à l'entrée de la caméra.
Information on the power consumption of individual camera models can be found in the model data sheet.
|
Note on power supply of the GigE uEye LE The GigE uEye LE can be supplied with voltage either via the 10-pin Molex connector or the 2-pin terminal strip. Do not use both power supplies simultaneously for the camera power supply! |
|
Keep in mind that a voltage drop will occur when you use long cables for power supply to the camera. Choose the size of the cable in such a way that the supply voltage available at the input of the camera is at least 12 V. |
TWI (Two Wire Interface) operation
The TWI (Two Wire Interface) is operated with a clock frequency of approx. 400 kHz. Multi master mode is not allowed on the TWI while the GigE uEye LE camera is used.
