Please enable JavaScript to view this site.

IDS Software Suite 4.96.1

Navigation: D: Specifications

uEye SE USB 3.1 Gen 1

Scroll Previous Top Next More

 

Camera specifications

Design

Mechanical specifications uEye SE USB 3.1 Gen 1

Housing/board level

+/+

Dimensions height x width x depth

Housing version: 34 x 44 x 47 mm

PCB version: 29.5 x 40 x 25 mm

PCB version with C-mount: 34 x 44 x 31 mm

IP code housing version

IP 30

Protection against the ingression of small particles (diameter ≥ 2.5 mm)

No protection against water

IP code PCB version

IP 00

No protection against the ingression of particles

No protection against water

Lens mount

C-Mount, see Optical specifications uEye SE USB 3.1 Gen 1

Mounting holes bottom/top/side/front

Housing version: 4/0/0/0

PCB version: 2x back, see Notes on PCB version uEye SE USB 3.1 Gen 1

PCB version with C-mount: 2/0/0/0

Thread diameter

M3

Status LED

Status LED uEye SE USB 3.1 Gen 1

Ambient conditions

Ambient conditions uEye SE USB 3.1 Gen 1

Connectors

Electrical specifications uEye SE USB 3.1 Gen 1

Interface connector

USB Type-C®, screwable

Power supply

USB

I/O connector

8-pin Hirose HR25, screwable

Optocoupler for I/O

1/1

Trigger input/Flash output/GPIO

1/1/2

PWM (pulse-width modulation)

+

Serial interface

-

TWI (Two Wire Interface)

-

Special features

Internal pixel preprocessing

Supports USB Power Delivery

Image memory (approximately)

128 MB

hint_info

USB 3/USB 3.1 uEye cameras are limited usable under USB 2.0. Depending on the camera model, not all camera functions are available in USB 2.0 mode. USB 3/USB 3.1 uEye cameras are optimized for USB 3.0 ports and are not tested by IDS Imaging Development Systems GmbH under USB 2.0.

Please note that due to the high performance of modern sensors, some USB 3/USB 3.1 uEye models are not supported in USB 2.0 mode anymore, as the USB 2.0 interface does not provide enough power.

© 2022 IDS Imaging Development Systems GmbH