| LineSelector |
Selects the physical line (or pin) of the external device connector to configure. |
| LineMode |
Controls if the physical Line is used to Input or Output a signal. |
| LineInverter |
Controls the inversion of the signal of the selected input or output Line. |
| LineStatus |
Returns the current status of the selected input or output Line. |
| LineStatusAll |
Returns the current status of all available Line signals at time of polling. |
| LineSource |
Selects which internal acquisition or I/O source signal to output on the selected Line. LineMode must be set to Output. |
| LineFormat |
Controls the current electrical format of the selected physical input or output Line. |
| LineFilterSelector |
Selects the input filter to configure. LineMode must be Input. |
| LineFilterWidth |
Width of the filter in microseconds. |
| LineActivationVoltage |
The voltage level to activate the line. |
| VoltageExternalEnable |
Controls if the external voltage is enabled. |
| ExposureActiveOutputSignalMode |
Selects the output signal mode of the ExposureActive LineSource. |
| UserOutputSelector |
Selects which bit of the User Output register will be set by UserOutputValue. |
| UserOutputValue |
Sets the value of the bit selected by UserOutputSelector. |
| UserOutputValueAll |
Sets the value of all the bits of the User Output register. It is subject to the UserOutputValueAllMask. |
| UserOutputValueAllMask |
Sets the write mask to apply to the value specified by UserOutputValueAll before writing it in the User Output register. If the UserOutputValueAllMask feature is present, setting the user Output register using UserOutputValueAll will only change the bits that have a corresponding bit in the mask set to one. |